Ordinance 1999-1316 - Laserfiche WebLink

Home Browse Search

B. The Uniform Administrative Code Provisions for the National Electrical Code, 1996 Edition, published by the International Conference of Building Officials, 5360 Workman Mill Road, Whittier, California, 90601-2298, is adopted by reference thereto and incorporated into and made a part of the Louisville Municipal Code. The purpose and subject matter of the Uniform Administrative Code Provisions for the National Electrical Code, 1996 Edition, include provisions which are intended to assist users of the National Electrical Code it its administration. The Uniform Administrative Code Provisions for the National Electrical Code are adopted in full, including the outline of contents and index thereto; except that Table 3-A to such code is adopted and amended to read as set forth in Section 15.48.020. Any references to the Uniform Administrative Code Provisions for the National Electrical Code shall be to the 1996, Edition of said provisions, and any references to the National Electrical Code shall be construed to include the such Uniform Administrative Provisions. Section 11. Chapter 48 of the Louisville Municipal Code is hereby amended by the addition of a new Section 15.48.060, reading as follows: 15.48.060 Article 225 amended. Article 225 of the National Electrical Code is amended by the addition of a new section 225-32 to read as follows: 225-32. Location. The disconnecting means shall be installed at an approved, readily accessible location nearest the point of entrance of the conductors either directly inside an exterior door at grade level or at grade level outside of each building or structure served. This disconnect location shall apply to conductors that pass through the building or structure in Article 225-31. Section 12. Chapter 48 of the Louisville Municipal Code is hereby amended by the addition of a new Section 15.48.070, reading as follows: 15.48.070 Section 230-70(a) amended. Section 230-70(a) of the National Electrical Code is amended to read as follows: 230-70(a). LOCATION. The Service disconnecting means shall be installed at an approved, readily accessible location outside of a building or structure at grade level. EXCEPTION NO.i: The service disconnecting means may be installed inside the building or structure provided it is directly inside an exterior door at grade level immediately adjacent to the entrance of the service conductors and metering equipment. EXCEPTION NO.2: A remote keyed switch may be installed in an 11