Ordinance 1973-423 - Laserfiche WebLink

Home Browse Search

(5) Upon receipt of the plat and the recommendation of the Planning Commission, the City Council shal I approve, disapprove or refer the plat back to the Planning Commission for further study. If the plat is disapproved or referred, the reasons shal I be stated in writing and furnished to the subdivider. (6) Fol lowing acceptance of the Final Plat by the City Counci I, the Plat shal I be signed by the Mayor and attested by the City Clerk. The City Clerk shal I then record the Plat in the office of the Boulder County Clerk and Recorder. The subdivider shal I furnish to the City Clerk the recording fee required by the Boulder County Clerk and Recorder prior to recording of the Plat. (B) Form of the Final Plat. (I) A map of the plat shall be drawn at a scale of I" = 100' or larger with the use of permanent lines or ink and the outer dimensions of the map shal I be 24" x 36". The drawing shal I be made on a repro- ducible linen or mylar. A photographic copy on matt fi 1m equal in qual ity to ink lines on mylar wi I I be considered as an original. Maps of two or more sheets shal I be referenced to an index map placed on the first sheet. . (2) An original, a sepia, a linen print and three (3) paper copies of the Final Plat shall be prepared and submitted. Also, a reproducible reduction at 8 1/2" x 14" of the Final Plat shal I be submitted. (C) Contents of the Final Plat. (I) The title under which the subdivision is to be recorded; (2) Accurate dimensions for al I lines, angles, and curves used to des- cribe boundaries, streets, af leys, easements, areas to be reserved for public use, and other important features. AI I curves shal I be circular arcs and shal I be defined by the radius, central angle, tangent, arc and chord distances and chord bearings. AI I dimensions, both linear and angular, are to be determined by an accurate con- trol survey in the field which must balance and close within a limit of one in ten thousand. No final plat showing plus or minus dimensions will be approved; (3) Names of al I adjoining subdivisions with dotted lines of abutting lots. If the adjoining land is unplatted, it should be shown as such; (4) An identification system for al I lots and blocks and names for streets; (5) An identification of the streets, alleys, easements, parks, other public facil ities as shown on the plat and a dedication thereof to the pub I i c use; (6) Total acreage and surveyed description of the area; (7) A description of al I monuments, both found and set, which mark the boundaries of the property, and a description of al I control monu- ments used in conducting the survey; (8) A statement by the land surveyor that the survey was performed by him in accordance with Colorado Revised Statutes, Chapter 51, Article 2 (1963, as amended in 1967) or under his direct respons- ibi lity, supervision and checking; 2-4