Ordinance 2000-1346 - Laserfiche WebLink

Home Browse Search

11. 12. 13. 14. 15. (See diagram Exhibit A.2). Section 807.4 is amended by the addition of a new Section 807.4(a) to read as follows: No domestic dishwashing machine shall be directly connected to a drainage system or food waste disposer without the use of an approved dishwasher airgap fitting on the discharge side of the dishwashing machine. Listed airgaps shall be installed with the flood level (FL) marking at or above the flood level of the sink or drainboard, whichever is higher, or separately trapped with the airgap located on the stand pipe (See diagram Exhibit A.3). Section 911.0 is amended by the addition of a new Section, to read as follows: Section 911.1. Single bathroom groups-a single bathroom group of fixtures may be installed with the drain from an individually vented lavatory or lavatories serving as a wet vent for a bathtub, shower compartment, or floor drain and for a water closet provided the requirements listed below are met: Section 911.1(a). Not more than four fixture units drain into a minimum 2 inch diameter wet vent. Kitchen sinks, dishwashers, or automatic clothes washer connections are not permitted. Section 911.1 (b). The horizontal branch drain connects to the stack at the same level as the water closet drain; or it may connect to the upper half of the horizontal portion of the water closet bend at an angle not greater than 45 degrees from the direction of flow. Section 911.1(c). Trap arm sizes and lengths shall conform to tables 7.3, 7.5 and 10.1 (See diagram Exhibit A.4). Section 1009.0-1009.7 is amended by the adoption of an illustrative diagram for the minimum requirements for grease trap, grease interceptor, oil or sand trap (See diagram Exhibit A.5). Section 1015.0 is amended by the addition of the following exception, to read as follows: Section 1015 Exception: Special regulation s by the Public Works Department may supersede this requirement. Appendix H 106.3 is amended by the addition of a new Section to 6